calcination temperature中文是什么意思

• 煅烧温度

• "calcination"中文翻译    n. 1.【化学】煅烧，焙烧；(石灰的)烧成。 2.【冶 ...
• "temperature"中文翻译    n. 1.温度，气温。 2.体温。 3.〔口语〕发烧，高 ...
• "high temperature calcination" 中文翻译 :    高温煅烧
• "calcination" 中文翻译 :    n. 1.【化学】煅烧，焙烧；(石灰的)烧成。 2.【冶金】氟化法；烧矿法；(铁矿的)整矿法。
• "calcination furnace" 中文翻译 :    灰化炉; 煅烧炉
• "calcination in clump" 中文翻译 :    堆垒煅烧
• "calcination in dumps" 中文翻译 :    堆垒煅烧
• "calcination in heaps" 中文翻译 :    堆摊煅烧
• "calcination loss" 中文翻译 :    灼烧损失
• "calcination of oxides" 中文翻译 :    氧化物煅烧
• "calcination plant" 中文翻译 :    煅烧车间
• "calcination process" 中文翻译 :    煅烧过程
• "calcination ratio" 中文翻译 :    煅烧出产率
• "calcination technique" 中文翻译 :    煅烧技术
• "calcination zone" 中文翻译 :    煅烧带
• "condition of calcination" 中文翻译 :    锻烧条件
• "conditions of calcination" 中文翻译 :    锻烧条件; 煅烧条件
• "degree of calcination" 中文翻译 :    煅烧程度
• "fluidized calcination" 中文翻译 :    流态化床煅烧
• "gypsum calcination" 中文翻译 :    石膏煅烧
• "loss of calcination" 中文翻译 :    煅烧损失
• "partial calcination" 中文翻译 :    部分烧结
• "reverberatory calcination" 中文翻译 :    反焰煅烧
• "vacuum calcination" 中文翻译 :    真空煅烧
• "alumina calcination plant" 中文翻译 :    氧化铝煅烧车间

• The effects of calcinations temperature and holding time on the perovskite phase of synthesized pmn - pt have been studied
  并研究了煅烧温度及保温时间对合成材料单相性的影响。
• The f and n came from the precursor solution and the amount of f decreased with increasing calcination temperature
  其中f和n元素来源于前驱体溶液，且tio _ 2薄膜中的f元素含量随热处理温度的升高而减少。
• The effects of doping ratio , calcinations temperature and calcinations time on the structure and the particle size have been comprehensively studied
  系统研究了掺杂比，热处理温度，热处理时间等制备工艺过程对ato纳米粉体相组成和粉体粒度的影响。
• The reaction activity of the catalyst can be adjusted by changing the preparing condition , which including the calcination temperature , the metal load and the carrier
  制备过程中焙烧温度、负载量以及不同催化剂载体的选用都会影响所得催化剂的性能。
• With increasing calcination temperature , the photocatalytic activity of the tio2 thin films gradually increased due to the improvement of crystallization of the anatase tio2 thin films
  随热处理温度的升高，薄膜的光催化活性逐渐增加，这是由于薄膜中锐钛矿相tio _ 2的形成和tio _ 2晶化程度的提高。
• When the calcinations temperature fell into the scope of 300 - 400 , its resistance begun to decrease sharply . however , the resistance almost kept unchanged under higher calcinations temperature
  电阻值随热处理温度的升高而下降，在300 ? 400左右时，电阻值下降很快，继续升高热处理温度，电阻值减小趋势变缓。
• The precursor method could solve the problem that the appearance of pyrochlore phase during the synthesis procedure by avoiding the direct reaction between pbo and nb _ ( 2 ) o _ ( 5 ) . furthermore it also could decrease calcination temperature and pbo volatility
  采用二次合成法制备pmn - pt钙钛矿相，避免了pbo和nb _ 2o _ 5的直接反应，从而抑制了焦绿石相的生成。
• Compared with 3 % , the temperature of polymorphic transition between anatase and rutile of 8 % which is the molar quantities of mixed rare earth is a little lower . the calcination temperature is a main reason which influences the structure of phase
  掺入镝的含量8时，锐钛矿相向金红石相的转变温度与3相比有所降低，所以煅烧温度是影响产物结构的主要原因。
• The power prepared was examined by many kinds of analytic measures , like as xrd , xps , tem , sem and x rays fluorescence , etc . the sol - gel method was used to synthesize dy - doped titanium oxide , the impact of elements such as solvent ' s quantities , temperature , ph value , calcination temperature on the course of sol - gel is studied , and the quantities of mixed rare earth is also studied on the influence about the structure of phase , thus established the best technology parameter
  本文对掺杂稀土元素镝的氧化钛和氧化锆超微陶瓷粉末的制备的工艺过程进行了研究，并用xps 、 xrd 、 tem 、 sem和x射线荧光等多种测试手段对制得的粉末进行了分析。用溶胶-凝胶法合成氧化镝/氧化钛的陶瓷粉末，研究了溶剂量，温度， ph值，煅烧温度等对溶胶-凝胶过程的影响，以及掺杂稀土量对相结构的影响，从而确立了最佳的工艺参数。
• The appropriate calcinations temperature is about 700 , and the tetragonal sno2 phase crystal structure of the particles remained unchanged when sb was doped to it . as the calcinations temperature increasing and the calcinations time prolong , the size of particles grows and the crystallization tend to be complete . study on the electrical properties of ato powders prepared by hydrothermal synthesis was performed in - depth , the most optimal electrical properties are obtained at doping ratio of 11 percent
  水热法制备的ato纳米粉体在热处理温度700左右较为适宜，锑的掺杂并未改变粉体的四方相金红石结构，随锑掺杂量的增加，粉体的粒度变小；随热处理温度的升高和热处理时间的延长， ato粉体的粒度增大，晶体结构趋于完整。

• calcination temperature 意味
• calcination temperatureとは意味焼成温度｛しょうせい おんど｝